TCI HGP - Manual (Page 5)

S T A N D A R D O P T I O N ( S )
Standard Option (S) HGP IOM Manual 5
General Safety Instructions
These safety instructions are intended for all work on the HGP. Additional safety instructions are
provided at appropriate points on other sections of this manual.
Warning Be sure to read, understand, and follow all safety instructions.
Warning
Only qualified electricians should carry out all electrical
installation and maintenance work on the HGP filter.
Warning
All wiring must be in accordance with the National Electrical
Code (NEC) and/or any other codes that apply to the
installation site.
Warning
Disconnect all power before working on the equipment.
Do not attempt any work on a powered HGP filter.
Warning
The HGP filter, drive, motor, and other connected equipment
must be properly grounded.
Warning After switching off the power, always allow 5 minutes for the
capacitors in the HGP filter and in the drive to discharge before
working on the HGP, the drive, the motor, or the connecting
wiring. It is a good idea to check with a voltmeter to make sure
that all sources of power have been disconnected and that all
capacitors have discharged before beginning work.
!
!
!