TCI HGA Manual - Manual (Page 87)

87
Fault Screen
This button takes the user to the “Active Fault” screen (see Figure 7.11) which lists all of the active faults.
The faults will stay in this list until the “Reset”, or “Stop” button is pressed or the fault self clears. From here
the user can also go to the “Fault History” screen.
Figure 7.11 – Fault Screen
Table 7.11 – Fault Screen Elements
Screen Element Description
Stop Button Turns off the HarmonicGuard Active filter.
Reset Button
This button will remove all faults from the list if the fault conditions
have cleared. Once cleared, a fault will still be viewable in the
fault history log.
Fault Trip Entry
Display
When a fault occurs the fault screen will display information about
the fault including the (from left to right across the screen):
• Fault bit mask number
• Fault timestamp
• Fault code (see Table 7.12)
• Fault description
History Button
This button will take the user to the “Fault History” sub screen
where previous faults can be reviewed.