BT DECTfax Plus Fax Machine and digital telephone system - Manual (Page 17)

Setting up
15
2 Press the ᮡ and ᮢ buttons to scroll through
the options. You can also select WITHOUT
RING to have no ringer tone at all.
3 Use the + and - buttons to select the volume.
There are 4 levels.
4 Press OK/Menu to confirm your
choices.When WITHOUT RING is selected the
TEL icon will flash constantly in the display.
Setting the receive mode
You can set your DECTfax Plus to answer calls
automatically or manually. There are two auto
answer modes, to allow you to receive just
telephone calls and faxes or telephone calls,
faxes and voice messages.
To set the receive mode
• Press the Tel Fax Tad button to switch
between manual; phone and fax; and phone,
fax and answering machine.
Tel mode
When set to Tel mode, the display shows:
All calls must be answered manually. If the call
is a fax (you will hear beeps from the other fax
machine), wait a few seconds and the
basestation will automatically switch to fax
receive mode. If it does not, press # then
7 on
your handset to activate fax receive mode.
Tel/Fax mode
When set to Tel/Fax mode, the display shows:
Your DECTfax Plus will automatically
determine whether an incoming call is a phone
call or a fax call.
Tel/Fax/Tad mode
When set to Tel/Fax/Tad mode, the display shows:
If a call is unanswered, the call will be taken
first by the answering machine. If the call is a
fax it will be received automatically.
Your DECTfax Plus machine is now fully set
up for use. To make any changes to your
settings, simply repeat the procedures.