UVP BioChemi System with EpiChemi II Darkroom - Manual (Page 14)

6.
Installing LabWorks and Capture Driver
Computer
The computer power cable should plug directly into a power strip or surge protector. Find
and locate the mouse, keyboard, and other accessories, plug in and secure all
connections. Start up the computer once all of the connections have been made and the
power is attached.
NOTE: If the computer has LabWorks pre-installed, skip the installation procedures.
Installation Procedure
1. Install board into computer in a PCI (white) slot (see Part 3 of this
section).
2. Boot system. New device should be detected (if not, skip to #15
below)
3. When prompted for a driver, choose search for best driver.
4. Select ‘Specify location’ then click the ‘browse’ button or click ‘Have
disk’
5. Select your CD drive with the Labworks 4 CD.
6. Browse to the following directory: \Drivers\Camera Drivers\Bio-Chemi
Camera Driver\Hardware drivers\Bio-Chemi Driver\9x2000 (or Nt if
installing on an NT system)
7. Click OK and/or Next until Finished.
8. If prompted to reboot, choose Yes or OK. If not, reboot anyway.
9. Install LabWorks 4.0 (this may be done before or after the board
installation). Add the Security Dongle as described in below.
10. Install Camera Driver by browsing the LabWorks CD
11. Go to the following folder: \Drivers\Camera Drivers\Bio-Chemi
Camera Driver\new
12. Copy the following file: captsed.dll (If you don’t see this file, skip to
#26 below)
13. Paste captsed.dll into your LabWorks 4 folder on your Hard drive
(probably C:\)
14. Board and camera driver should be properly installed and working
(Open and Run LabWorks)
******************************
15. If board is not detected upon reboot. Go into Start -> Settings ->
Control Panel
16. Double click Settings
WWW.UVP.COM US Technical Support: 1.800.452.6788
UK Technical Support: +44.0.1223.420022
14