UVP ChemiDoc-It TS2 Imagers - Manual (Page 11)

GelDoc-It
TS2
and ChemiDoc-It
TS2
Imagers 11
Power Button
Power Indicator
Lights
Using the System
Powering Up the System
Set the black power switch on the back of the system to the ON (I)
position. Once plugged in to a wall outlet and the black power switch
on the back of the system is placed in the ON (I) position, the
GelDoc-It
TS2
and ChemiDoc-It
TS2
systems are always powered on.
Press the POWER button on the front of the
system to power on the internal
computer/touch screen and access controls for
the camera, lenses, lighting and other
functions.
The Power Indicator Lights on the front of the unit indicate when
the system’s main power and ultraviolet illumination are on. Main
Power will illuminate green when the black main power switch on the
back of the unit is in the ON (I) position (this does not indicate that
the internal computer or touch screen are on).
Ultraviolet On will illuminate red when ultraviolet
illumination is active within the darkroom.
The POWER button will illuminate blue when the internal computer
and touch screen are on. (Note: The black main power switch on the
back of the unit must be in the ON (I) position in order for the internal
computer and touch screen to function.)
Note: It is recommended to leave the power switch on the back of the system in the ON position except
when the system will not be used for an extended period of time (one day or longer).
Operating the TS2 Software Interface
Upon startup, the internal computer will proceed through the boot-up process. When complete, the screen
will display the Windows desktop. The TS2 Software screen, similar to the one below, will automatically
open shortly thereafter:
To exit the TS2 Software interface, press either the close (X) or minimize (_) buttons at the top right corner
of the software (see red circle above). To power down the system, exit the TS2 Software interface by
pressing either the close (X) or minimize (_) buttons at the top right of the software. Then, using the
Windows “Start” menu, select “Shut Down”.
Refer to Touch Screen Interface in this manual for further instructions on using the software.