UVP ChemiDoc-It TS2 Imagers - Manual (Page 23)

GelDoc-It
TS2
and ChemiDoc-It
TS2
Imagers 23
Touch the Focus button to activate lens
focus adjustment. Use the slider bar to
make adjustments to this setting.
The current focus setting will be indicated
below the word “Focus” on the button
(here, the focus is “25%”) as well as
above the slider bar.
This function is active when the button
reads “Focus” in yellow lettering and the
word “Focus” appears below the slider
bar.
When one or more images are open on
the main TS2 screen, touch the purple “X”
in the upper-right corner of the open
image to close that image.
NOTE: If an image has been captured
but not saved, touching the purple “X”
will permanently delete the image. The
TS2 Software will NOT prompt the user
to save the image!
Touch the “i” button to view information
pertaining to the open image. Information
includes exposure time, binning settings
(where applicable), illumination, focus and
aperture settings. Touch the “i” button
again to close the image information
screen.
Touch the Minimize (“_”) button in the
upper-right corner of the screen to
minimize the TS2 Software. Touch the
Close (“X”) button in the upper-right
corner of the screen to close the TS2
Software.
Connecting to a Network
The TS2 System has built-in network capability, both wired and wireless. While it is fairly simple to connect
the system to the network, it is highly recommend to obtain assistance from a network administrator to
ensure that the process is completed properly.
Follow Microsoft or local standard network protocols for network configuration. To exit the TS2 Software
interface and access Microsoft Windows for network configuration, touch the Minimize (“_”) button in the
upper-right corner of the software to minimize the TS2 Software.
Install Drivers or Additional Software
In the event that additional drivers or software must be installed on the system, exit the TS2 Software
interface and access Microsoft Windows by touching the Close (“X”) button located in the upper-right corner
of the main TS2 screen.
To install drivers or additional software, copy the software to an external storage device, open Windows
Explorer, navigate to the appropriate folder and run the desired program. The system can accept USB, SD
or MMC as methods of software installation.