UVP GelDoc-It TS Imaging System - Manual (Page 10)

GelDoc-It TS Imaging System 10
Adjusting the Screen Angle
1. To adjust the angle of the screen, loosen the
knobs on each side of the monitor. Twist each
knob counter-clockwise (note that you will
actually be turning each knob in the opposite
direction from each other).
2. Tilt the screen to the desired angle.
3. Turn each knob clockwise to tighten.
Operating the TS Software (When Using the Manual Lens)
The system will go through the boot-up process. When ready, the LCD will display the GelDoc-It TS
software screen similar to the one below:
To shut down the GelDoc-It TS software, touch the X on the bottom left corner of the screen.
To turn the system off, press the MAIN POWER button or power down from the Windows icon on the bottom
right corner of the screen.
Refer to the TS Software User Manual for further instructions on using the software.