WarmlyYours TempZone FLEX (Twin) Conductor 120V or 240V - Manual (Page 14)

STEP 1 STEP 2 STEP 3 STEP 4
Install WarmlyYours
Heating Rolls
1. Install the floor heating system as
recommended, adhering the mesh every
6-8 inches with hot glue (or staples if
using cork insulation), carefully routing the
power leads alongside the system back
to the power supply. Never staple directly
over the wires.
2. Install the thermostat sensor probe
(if applicable) 6” into the heating mat
centered directly between the heating
wires. The sensor wire must not contact
the heating wire. Connect circuit check (if
purchased).
3. Use a flat trowel to encase the heating
rolls in 3/8” of self-leveling cement or
latex-portland cement and allow proper
manufacturer recommended cure time.
Follow manufacturers recommended
mixing directions carefully.
4. Perform 2nd ohm test.
Apply the Flooring
Adhesive (glue)
1. Apply manufacturer’s recommended
adhesive as per flooring installation
instructions.
Install Laminate /
Engineered Wood
Flooring
1. Install laminate or engineered wood
flooring as per manufacturer’s
recommendations.
2. Perform and record 3rd ohm test on
Warranty Registration Card.
Electrical Connections
1. The electrical wiring should follow the
wiring instructions provided with the
thermostat.
2. The thermostat is mounted in a double-
gang wall box with a single-gang mud ring.
3. The heating rolls must be connected to the
electrical service via a GFCI (Ground Fault
Circuit Interrupter). The GFCI feature is
incorporated in the thermostat.
4. All electrical connections should be
performed by a licensed, certified
electrician.
Allow proper adhesive & setting material
cure time as recommended by the
manufacturer before powering up the
WarmlyYours electric radiant heat system.
Glue Down Laminate & Engineered Wood Floors - Installation Guide
13