WarmlyYours TempZone FLEX (Twin) Conductor 120V or 240V - Manual (Page 17)

Important General Considerations
IMPORTANT INFORMATION
The most important consideration is to maintain the
integrity of the Heating Element; following these simple
rules can easily do this:
1. NEVER CUT the Heating Element.
2. NEVER CUT the Heating Roll(s) to make it shorter.
3. NEVER fold or position the Heating Element so that it
overlaps itself or other wires. The heating portion of the
heating device set shall not touch, cross over, or overlap
itself. This will cause dangerous overheating.
4. NEVER run the Cold Lead Wires or Sensor Wire across the
Heating Element.
5. NEVER place built-in cabinets and other furniture with solid
bases on the heated portion of the floor.
6. ALWAYS make sure the system is inspected and the Ohms
tested before, during and after installation.
7. ALWAYS make sure everyone involved in the installation is
aware of the care needed to protect the Heating Element
from damage.
8. ALWAYS maintain consistent spacing when positioning the
Heating Element.
9. NEVER connect two Heating Rolls to each other (in series).
Only connect them in parallel to the same control device.
10. Tiles will only be warm where the heating wire is installed.
If there is no heating wire directly under the area, it will not
be warm.
11. A dedicated circuit is recommended for the system.
Note for the System Installer
Provide the homeowner with a copy of the Installation Plan provided to
you by WarmlyYours.
This will help you and future owners of the home. The plan should indicate where the
WarmlyYours Heating Roll(s) is installed, the location of the control device and the
amperage of the system. If a sensor is used, indicate its location on the plan. The electrician
should put the code labels (UL) from any Heating Roll used in a convenient place such as
the circuit breaker box. The labels should have Ohm resistance readings written on them.
These are a useful reference for future inspections and possible troubleshooting.
Complete the Warranty Card and return to WarmlyYours within 90 days.
Keep your plan and this installation manual safe for future reference.
Record your installation information here:
Name/Company of Electrician ______________________________________________
Address _______________________________________________________________
Tel.# __________________________________________________________________
Location of UL labels _____________________________________________________
Name/Company of Floor Installer ___________________________________________
Address _______________________________________________________________
Tel.# __________________________________________________________________
Location of Installation Plan ________________________________________________
Date of installation _______________________________________________________
The instructions in this manual must be observed when installing the WarmlyYours Floor
Heating System. Failure to follow these instructions may inhibit optimal performance of
your Floor Heating System and void the system warranty. A tile-setter, flooring contractor
or qualified Do-It-Yourselfer can install the WarmlyYours Heating Roll(s). However, a
qualified electrician must complete the electrical connections of the system to the main
electrical circuit in accordance with the National Electrical Code and your local codes. We
trust that your installation goes well and that you enjoy your warm floors!
16