Wilson Manifolds 462259 5.9 Dodge/Cummins Performance Kit - Manual (Page 10)

10
14) Install the two (2) 55mm studs supplied with the hardware kit (indicated in yellow). These
studs will take the place of two of the intake manifold bolts. Install the studs so they are hand
tight. Blue loc-tite can be used on the studs if desired but not necessary.
15) Install the manifold base plate along with the factory manifold base plate bolts (indicated in
yellow) and torque to 18 ft lbs.. There are two bolts not highlighted in the picture below toward
the back.