Wilson Manifolds 462259 5.9 Dodge/Cummins Performance Kit - Manual (Page 13)

13
20) Install the supplied intake horn gasket.
21) Install the cast Wilson elbow. You may have to wiggle it in but it will fit. Take caution not to
catch the oil dipstick tube on the elbow (highlighted in red). Install the 12pt nuts on the studs
(indicated in yellow). Install the 35mm allen head bolts on the manifold where the factory bolts
were located (indicated in green). Do not tighten any nuts or bolts until manifold is in place and
in final position before final torque of 18 ft lbs is applied.