Rockwell Automation 20D-MDI-C1 Multi-Device Interface Option Board for PowerFlex 700S Drives - Manual (Page 16)

16 Multi-Device Interface Option Board for PowerFlex® 700S Drives
Install the Phase II Control Cassette
Frame 9 - 13 Size Drives
Task Description
Slide the cassette onto the mounting bracket.
Tighten the screws on the face of the cassette.
Swing the Control Assembly in toward the control frame.
Tighten the captive screw.
Plug any I/O and communications cables in to the Control Assembly.
Attention: Hazard of permanent eye damage exists when
using optical transmission equipment. This product emits
intense light and invisible radiation. Do not look into fiber-optic
ports or fiber-optic cable connectors.
Important: Minimum inside bend radius for SynchLink and ControlNet
fiber-optic cable is 25.4 mm (1 in.). Any bends with a shorter inside
radius can permanently damage the fiber-optic cable. Signal
attenuation increases with decreased inside bend radii.
Unplug any fiber optic ControlNet and SynchLink cables from the
Control Assembly.
A
B
C
D
E
!
F
=
Frame 1 - 6 Size Drives
Task Action
Slide the control cassette onto the mounting bracket.
Tighten the screws on the face of the cassette.
Connect the cables at the ends that connect to the main
Control board.
A
B
C
A
B
C
D
BR1 BR2 DC+ DC- PE
U/T1 V/T2 W/T3 R/L1 L2
A
B
C