Rockwell Automation 20D-MDI-C1 Multi-Device Interface Option Board for PowerFlex 700S Drives - Manual (Page 3)

Multi-Device Interface Option Board for PowerFlex® 700S Drives 3
Step 2: Remove the Drive
Cover(s) Frame 1 - 6 Size Drives
Esc
7 8 9
4 5 6
1 2 3
. 0 +/-
Sel
Jog
Alt
Exp Param #
S.M.A.R.T. Exit Lang Auto / Man Remove
DRIVE DRIVE
SYNCHLINK ENABLE
A
C
B
D
E
Phase I Control
Task Action
Loosen the captive screw.
Push down on the front cover.
Pull the front cover away from the assembly.
Pull the side cover forward.
Lift the side cover off of the control assembly.
A
B
C
D
E
Phase II Control
Action
Frames 1-4
Locate the slot in the upper left corner of the drive cover. Slide
the locking tab up and swing the cover open. Special hinges
allow cover to move away from drive and lay on top of an
adjacent drive (if present).
Frame 5
Slide the locking tab up, loosen the right-hand cover screw and
remove the cover.
Frame 6
Loosen the two screws at the bottom of the drive cover. Carefully
slide the bottom cover down and out. Loosen the two screws at
the top of the cover and remove the cover.
=