Connecting power and equipment to the ups – Rockwell Automation 1609-P10000E 8000 / 10000 VA Uninterruptible Power Supply User Manual
Page 5
4
Connecting Power and Equipment to the UPS
1. Hardwire the UPS (see Hardwiring).
2. Connect equipment to the UPS.
3. Turn on all connected equipment. To use the UPS as a master on/off switch, be sure that all
connected equipment is switched ON.
4. Press the
button on the front panel to power up the UPS.
•
The battery charges to 90% capacity during the first three hours of normal operation. Do not
expect full battery run capability during this initial charge period.
O
PTIONS
q
External Battery Pack (1609-PXBP)
q
Rail Installation Kit (1609-PRK1)
q
Isolation Transformer (1609-5000CCT)
C
IRCUIT
B
REAKERS
Input Circuit Breaker
8000/10000 VA
The UPS is protected from extreme overloads when in ON position.
The breaker must be on for the UPS to operate.
Output Circuit Breaker
8000/10000 VA