Rockwell Automation 1609-P10000E 8000 / 10000 VA Uninterruptible Power Supply - Manual (Page 7)

6
O
PERATION
F RONT D ISPLAY P ANEL
Indicator Description
Online The UPS is drawing utility power and performing double conversion to supply
power to connected equipment (see Troubleshooting).
On Battery The UPS is supplying battery power to the connected equipment.
Bypass The UPS is in bypass mode, sending utility power directly to connected equipment.
Bypass mode operation is the result of an internal UPS fault, an overload condition
or a user initiated command either through an accessory or the manual bypass
switch. Battery operation is not available while the UPS is in bypass mode (see
Troubleshooting).
Fault The UPS detects an internal fault (see Troubleshooting).
Overload The connected loads are drawing more power than the UPS power rating (see
Troubleshooting).
Replace
Battery The battery is disconnected or must be replaced (see Troubleshooting).
Feature Function
Power On Press this button to turn on the UPS. (Read on for additional capabil ities.)
Power Off Press this button to turn off the UPS.
Feature Function
Normal /Bypass Manually switch connected equipment to b ypass mode, so that utility power is
sent directly to connected equipment. Battery operation is not available while
the UPS is in bypass mode. (See Troubleshooting.)