Rockwell Automation 1608P ProDySC User Manual, 200 A - Manual (Page 11)

Rockwell Automation Publication 1608P-UM003A-EN-P - September 2013 11
Installation Chapter 2
4- Wire Models Bulletin 1608P part numbers containing V4 are configured for 4-wire source (L1,
L2, L3, N) and either 3-wire or 4-wire loads. The source N conductor must be
connected for proper operation of these models. Connect both input and output
N conductors to the bus bar labeled NEUTRAL (See
Figure 5 ). Figure 4 shows
the 4-wire ProDySC system wiring schematically, including the recommended
Bypass Switch.
Figure 4 - ProDySC 4-Wire Configuration.