Rockwell Automation 1402-LSM Line Synchronization Module Installation Instructions User Manual
Page 33
Chapter 3
General Operation
3–11
Configuration Software Support
6200 Software
Setup assistance for the LSM module is provided through the 6200 version
4.4 or later I/O Configuration Software. This configuration software contains
the functionality to configure the module and to monitor the data produced
by an operating module.
To make use of the configuration software, the ladder must exist with block
transfer instructions programmed as shown in Appendix C. (See Sample
Ladder listings in Appendix C) The BTR instructions must occur through the
ladder to read data from the module. These are done through the use of the
sequencer and the data table values to insure that only one block transfer is
active at a given time.
This software also supports the setup of the Bulletin 1400 family of power
monitoring equipment. More 6200 I/O Configuration Software information
on the actual use of this tool is available in the 6200 Series software user’s
manual.
PLC Interface Continued