Rockwell Automation 1402-LSM Line Synchronization Module Installation Instructions - Manual (Page 75)

Appendix C
Sample Ladder Listing
C–9
Rung 2:23
Configuration data is valid and the sequence is complete.
| Config |
| Sequencer |
| |Config |Valid Complete |
| Data |Sequencer |Config data |
| Reset |Control |Data valid |
| B3 R6:0 B3 B3 |
+––––]/[––––+–––] [––––––––] [––––+––––––––––––––––––––––––––––––––––––( )–––––––+
| 2 | DN 4 | 5 |
| |Config | |
| |Sequencer | |
| |Complete | |
| |data | |
| |valid | |
| | B3 | |
| +–––] [–––––––––––––––+ |
| 5 |
Rung 2:24
Configuration is complete, return to run mode.
| |Config | |Ack. |Ack. | Config |
| |Sequencer |Active |Factory |User |Factory |User Sequence,& |
| |Complete |Transfer |Config. |Config. |Config. |Config. BT’S Done. |
| Data |data |Done |BTR |BTR |BTW |BTW Status |
| Reset |valid |Bit |Done Bit |Done Bit |Done Bit |Done Bit Data Valid |
| B3 B3 N[N10:0]:0 N52:0 N53:0 N59:0 N60:0 B3 |
+––]/[––+–––] [––––––––] [––––––––] [–––––––] [–––––––] [–––––––] [––+–––( )–––––+
| 2 | 5 13 13 13 13 13 | 6 |
| | |
| |Config |
| |Sequence,& |
| |BT’S Done. |
| |Status |
| |Data Valid |
| | B3 |
| +–––] [––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
6
Rung 2:25
|
+––––––––––––––––––––––––––––––––[END OF FILE]–––––––––––––––––––––––––––––––––––+
Rung 23
Configuration data is valid
and the configuration
sequencer is done.
Rung 2:24
Configuration is complete
and all configuration
block transfers successful.
Return to run mode.
Rung 25
End of file.