Rockwell Automation 1402-LSM Line Synchronization Module Installation Instructions - Manual (Page 43)

Chapter 4
Application Information
4–9
Data Files Used
Table 4.4
Data File Data Description
b3/0 Internal Trigger
b3/1 Config Mode Enable
b3/2 Data Reset
b3/3 Run mode Sequence Complete
B3 b3/4 Valid Config Data B
b3/5 Config Sequence Complete/Data Valid
b3/6 Module Config Complete
b3/9 One–shot bit
b3/10 One–shot bit
N10 n10:0 Sequencer output (BT select word)
N21 Config mode sequencer input file.
For proper configuration with the sequencer at rung 2:7 set to a
length of 4 words, the following data MUST be in file N21.
N21:0 59 D Factory Configuration Parameters
N21:1 59 D Factory Configuration Parameters
N21:2 52 D Factory Acknowledge Configuration
N21:3 60 D User Configuration Parameters
N21:4 53 D User Acknowledge Configuration Parameters
N22 Run mode sequencer input file
For proper configuration with the sequencer at rung 2:8 set to a
length of 8 words, the following data MUST be in file N22.
N22:0 54 D Synchronizing Bus Error Parameters
N22:1 54 D Synchronizing Bus Error Parameters
N22:2 50 D Factory Configuration Parameters
N22:3 51 D User Configuration Parameters
N22:4 55
D Synchronizing Bus Voltage/Current Parameters
N22:5 54
D Synchronizing Bus Errors
N22:6 56 D Synchronizing Bus Power Parameters
N22:7 57 D Reference Bus Voltage Parameters
N22:8 58 D Diagnostic Parameters
Ladder Program Description
Continued