Rockwell Automation 1606-XLS960F-3 Power Supply Reference Manual - Manual (Page 20)

All parameters are specified at 24V, 2.5A, 230Vac input, 25ªC ambient and after a 5 minutes run-in time unless noted otherwise.
20 Rockwell Automation Publication 1606-RM032A-EN-P — April 2014
Bulletin 1606 Switched Mode Power Supplies
24. Accessories
24.1. 1606-XLC Wall Mounting Bracket
This bracket is used to mount specific units onto a flat surface without
a DIN rail.
24.2. 1606-XLSBUFFER48 Buffer Module
This buffer unit is a supplementary device for DC 48V power supplies. It delivers power
to bridge typical mains failures or extends the
hold-up time after turn-off of the AC power.
In times when the power supply provide
sufficient voltages, the buffer unit stores
energy in integrated electrolytic capacitors.
In case of mains voltage fault, this energy is
released again in a regulated process.
DC
Buffer
Unit(s)
Power
Supply
Load
AC
+
-
s
The buffer unit does not require any control wiring. It can be added in parallel to the load circuit at any given
point. Buffer units can be added in parallel to increase the output ampacity or the hold-up time.