Rockwell Automation 1394 INSTL.INSTRU.1394 TURBO FIRMW - Manual (Page 13)

Upgrading your 1394 GMC Turbo Firmware 13
Publication 1394–6.3 – November 1997
3. From the Settings menu, select Communications. The
Communications menu appears.
4. Set the following fields shown below:
Important: The COM Port you select from the Connector
menu depends on your computer hardware
setup. You need an unused COM port (9-pin
serial port) to connect your PC to the 1394 GMC
Turbo. In the example above we used COM1.
5. Select OK. The Communications window disappears.
6. From the Settings menu, select Binary Transfers. The Binary
Transfers window appears.
7. Select XModem/CRC.
8. Select OK. The Binary Transfers Window disappears.