Rockwell Automation 1394 INSTL.INSTRU.1394 TURBO FIRMW - Manual (Page 17)

Upgrading your 1394 GMC Turbo Firmware 17
Publication 1394–6.3 – November 1997
9. Close Terminal and Open GML.
10.Press the Control Init button while pressing the Control Reset
button. Continue to hold in the Init button until the 1394 GMC
Turbo completes the power up sequence (about 10 seconds). This
resets the baud rate on the serial communications port (Port A) to
9600. Refer to Figure 1 for button locations.
Important: If you were operating at a baud rate other than
9600, you will have to change the baud rate in
your GML program. Refer to your GML
manual for more information.
11. In GML, select Online from the Diagram menu. The Online
Manager window appears. As GML establishes communications
with the 1394 GMC Turbo, verify that the new firmware revision
number appear in the lower left corner of the Online Manager
Window.
12.Select Exit. The Online Manager Window disappears.
13.
If you: Then:
Uploaded your GML script
from the controller
1. Open the GML Script you
saved.
2. Select Download script
from the Script menu.
3. Resume operation.
4. Go to Step 14.
Have a copy of your GML
diagram loaded on your
computer
1. Open the GML diagram.
2. Select Online from the
Diagram menu.
3. Select Download Diagram.
4. Resume operation.
5. Go to Step 14.
14.Place the firmware upgrade label on the left side of the 1394
GMC Turbo next to the data name plate.