Rockwell Automation 1394 INSTL.INSTRU.1394 TURBO FIRMW User Manual
Page 6
Advertising
Upgrading your 1394 GMC Turbo Firmware
6
Publication 1394–6.3 – November 1997
4. While holding in the Control Init button, press and release the
Control Reset button. Continue to hold in the Control Init button
until the 1394 GMC Turbo completes the power up sequence
(about 10 seconds). This resets the baud rate on the serial
communications port (Port A) to 9600. Refer to Figure 1 for
button locations.
5. Verify that the 1394 GMC Turbo memory is unlocked. Refer to
Figure 1 for the lock’s location.
Figure 1
Inside the 1394 GMC Turbo
Remote I/O
Control
Status
0
1
2
Axis Link
&
RS422 Multi Drop
Control Address
Control
Reset
Control
Init
Axis Link
Status
Application
Program Lock
Serial
Port
Config
DH-485
(J2)
DH-485
(J1)
Control Reset
Control Init
Application
Program
Lock
Advertising