Rockwell Automation 1734-OB2EP Point I/O Protected Output Module Installation Instructions - Manual (Page 7)

POINT I/O Protected Output Module 7
Publication 1734-IN586A-EN-P - December 2001
3. Press on the module lock on the top of the module.
4. Pull on the I/O module to remove from the base.
5. Use a small bladed screwdriver to rotate the orange base
locking screw to a vertical position. This releases the locking
mechanism.
6. Then lift straight up to remove.
WARNING
!
When you connect or disconnect the Removable
Terminal Block (RTB) with field side power
applied, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
WARNING
!
When you insert or remove the module while
backplane power is on, an electrical arc can
occur. This could cause an explosion in
hazardous location installations. Be sure that
power is removed or the area is nonhazardous
before proceeding.