Connect the module to the devicenet network – Rockwell Automation 1756-DNB ControlLogix DeviceNet Scanner Module Installation Instructions User Manual
Page 18
Advertising
18 ControlLogix DeviceNet Scanner Module
Publication
1756-IN566D-EN-P - June 2008
Connect the Module to the DeviceNet Network
Attach the connector to the module’s DeviceNet port as shown below.
Tighten the screws on the connector as needed.
WARNING
If you connect or disconnect the DeviceNet connector with power applied to
this module or any device on the network, an electrical arc can occur. This
could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
31716-M
10-position
Linear Plug
DeviceNet Port
Connector
DeviceNet Drop Line or Trunk
Connector
Advertising