Set up the usb driver – Rockwell Automation 1756-DNB ControlLogix DeviceNet Scanner Module Installation Instructions User Manual
Page 20
Advertising
20 ControlLogix DeviceNet Scanner Module
Publication
1756-IN566D-EN-P - June 2008
Set Up the USB Driver
To connect your 1756-DNB scanner module via a USB port, you need to first
set up a USB driver. To set up a USB driver, perform this procedure.
1. Connect your 1756-DNB scanner module via a USB port.
The Found New Hardware Wizard dialog appears.
2. Check Install the software automatically (Recommended).
3. Click Next.
IMPORTANT
The 1756-DNB scanner module must be powered up before proceeding with
the USB driver setup.
Advertising