Rockwell Automation 1734-OE2V/C Point I/O 2-Current and 2-Voltage Output Analog Modules - Manual (Page 9)

POINT I/O 2 Current Output and 2 Voltage Output Analog Modules 9
Publication 1734-IN002C-EN-E - April 2005
Remove a Mounting Base
To remove a mounting base, you must remove any installed module,
and the module installed in the base to the right. Remove the
removable terminal block, if wired.
1. Unlatch the RTB handle on the I/O module.
2. Pull on the RTB handle to remove the removable terminal
block.
3. Press on the module lock on the top of the module.
4. Pull on the I/O module to remove from the base.
WARNING
When you connect or disconnect the removable
terminal block (RTB) with field-side power
applied, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.
WARNING
When you insert or remove the module while
backplane power is on, an electrical arc can occur.
This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is
nonhazardous before proceeding. Repeated
electrical arcing causes excessive wear to contacts
on both the module and its mating connector. Worn
contacts may create electrical resistance that can
affect module operation.