Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 127)

Publication 1738-UM001A-EN-P - February 2005
3
default data maps D-1
device bridging 5-4
DeviceNet communications
backplane autobaud 2-12
backplane baudrate 2-10
change of state P-3, 2-6, 2-23
cyclic P-4, 2-6, 2-23
polled P-4, 2-6, 2-23
strobe P-4, 2-6, 2-23
DeviceNet network 2-6
remove and reinsert modules 2-5
RSNetwork for DeviceNet 2-2
understanding 2-6
DeviceNet network, primary
configure 2-4
diagnositc tables 2-24
documentation
other ArmorPoint I/O products 2-7, P-5
double word boundaries 3-3
E
EDS Files 5-5
expansion power unit (1738-EP24DC) 2-7
expected packet rate 2-17
scanner setting in RSNetWorx for
DeviceNet 4-5
F
faulted node table 2-24
firmware
upgrading in the field 2-8
fixed boundaries 3-3
foreground to background poll ratio 2-17
scanner setting in RSNetWorx for
DeviceNet 4-5
G
going on line 4-8, 5-6
guidelines
using 1738-ADNX C-1
using the adapter 6-3
guidelines for using the adapter P-6
I
I/O data parameter
adapter 5-5
I/O modules
installing 3-4
removing from mounting base 3-5
I/O status word bit 2-22
idle node table 2-24
image table mapping 2-20
inputs and outputs
1738-ADNX B-19
installing
I/O modules 3-4
installing the adapter 1-1
interscan delay 2-17
scanner setting in RSNetWorx for
DeviceNet 4-5
M
MACID parameter B-9
map from parameters
scanner setting in RSNetWorx for
DeviceNet 4-6
mapping data 2-18
mapping I/O data
in auto start mode 3-3
module power 2-7
mount the adapter 1-1
mount the I/O base 1-1
mounting base
removing I/O modules 3-5
N
navigate between networks
1738-ADNX B-24
networks 2-2
DeviceNet 2-6, 2-18
PointBus 2-18
node address
setting 1-2
node status
cycling 2-14
node status table 2-24
O
on line
going 4-8, 5-6