Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 60)

Publication 1738-UM001A-EN-P - February 2005
4-8 Configure the DeviceNet Scanner Subnet
Go On Line
After you set configuration parameters, your scanner must go on line
to accept the configuration changes. Follow these steps:
1. Use the Network pulldown to go on line.
The software prompts you to save your configuration changes.
2. Choose your scanner’s network and apply the changes, as
shown below.
Chapter Summary and
What’s Next In this chapter, you learned how to configure the scanner. Move to
Chapter 5 to learn how to add the ArmorPoint DeviceNet adapter to
the DeviceNet scanner’s scanlist.
1. Click on Network.
2. Click on Online.
Click Yes.
Select the DeviceNet network
subnetwork.
This selection accesses the PointBus
to configure the adapter on the
DeviceNet network.
Click OK to apply the data
to your scanner.