Rockwell Automation 1734-OW2_OW4, Series C Point I/O 2 and 4 Relay Output Modules - Manual (Page 10)

10 POINT I/O 2 and 4 Relay Output Modules
Publication 1734-IN055F-EN-E - March 2012
Install the Module
The module can be installed before or after base installation. Make sure that the mounting
base is correctly keyed before installing the module into the mounting base. In addition,
make sure the mounting base locking screw is positioned horizontal in reference to
the base.
1. Using a bladed screwdriver to rotate the keyswitch on the mounting base
clockwise until the number required for the type of module being installed aligns
with the notch in the base.
2. Make certain the DIN rail locking screw is in the horizontal position.
You cannot insert the module if the locking mechanism is unlocked.
3. Insert the module straight down into the mounting base and press to secure.
The module locks into place.
Turn the keyswitch to align
the number with the notch.
Notch position 3 is shown.
Make sure the DIN rail
locking screw is in the
horizontal position.
1734-TB Base
45696