Mount the i/o base – Rockwell Automation 1734-OW2_OW4, Series C Point I/O 2 and 4 Relay Output Modules User Manual
Page 9
Advertising
POINT I/O 2 and 4 Relay Output Modules 9
Publication 1734-IN055F-EN-E - March 2012
Mount the I/O Base
To mount the I/O base on the DIN rail, proceed as follows:
1. Position the mounting base vertically above the installed units (adapter, power
supply or existing module).
2. Slide the mounting base down allowing the interlocking side pieces to engage the
adjacent module or adapter.
3. Press firmly to seat the mounting base on the DIN rail. The mounting base snaps
into place.
Slide the mounting base until the
interlocking side pieces engage the
adjacent module or adapter.
31586
Advertising