Rockwell Automation 1738-ADNX ArmorPoint DeviceNet Adapters, Series A - Manual (Page 6)

6 ArmorPOINT I/O DeviceNet Adapters
Publication 1738-IN014D-EN-E - December 2010
Install the mounting as follows:
1. Lay out the required points as shown in the drilling
dimension drawing.
2. Drill the necessary holes for M4 (#8) machine or self-tapping screws.
3. Mount the base using M4 (#8) screws.
4. Ground the system using the ground lug connection.
The ground lug connection is also a mounting hole.
Mounting Base
Install the Adapter
Follow the instructions to install the adapter.
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base
clockwise until the number 1 aligns with the notch in the base.
2. Position the module vertically above the mounting base.
The module bridges two bases.
3. Push the module down until it engages the latching mechanism.
You will hear a clicking sound when the module is properly engaged.
The locking mechanism locks the module to the base.
Ground lug connection
Latching mechanism
Keyswitch
43675