Rockwell Automation 1738-ADNX ArmorPoint DeviceNet Adapters, Series A - Manual (Page 8)

8 ArmorPOINT I/O DeviceNet Adapters
Publication 1738-IN014D-EN-E - December 2010
minor fault occurs, which is indicated by a flashing red Adapter Status LED.
Settings of 64…99 cause the module to use the last valid node address stored
internally. Example: The last setting internally was 40. If a change is made to
68, and then you power up, the address will default to 40.
The module is equipped with AutoBaud detect. AutoBaud lets the module
read the settings already in use on your DeviceNet network and automatically
adjusts to follow those settings.
Wire the Adapter
Follow the wiring instructions for the ArmorPOINT I/O
DeviceNet adapters.
1738-ADN12 and 1738-ADNX
1738-ADN18, 1738-ADN18P
(View into connector)
Pin 1 Drain
Pin 2 + V
Pin 3 - V
Pin 4 CAN_High
Pin 5 CAN_Low
Male in connector
43763 43764
Female out connector (1738-ADN12)
(Subnet out – 1738-ADNX only)
(View into connector)
Pin 1 Drain
Pin 2 + V
Pin 3 - V
Pin 4 CAN_High
Pin 5 CAN_Low
Male in connector
43746 43749
Female out connector
(1738-ADN18P only)