Removing the 1788-cn2ff – Rockwell Automation 1788-CN2FF ControlNet to Foundation Fieldbus H1 Linking Device Installation Instructions User Manual
Page 11
Advertising
ControlNet-to-Foundation Fieldbus H1 Linking Device 11
Publication 1788-IN051D-EN-P - February 2004
Figure 3 Install the 1788-CN2FF on to the DIN Rail
Removing the 1788-CN2FF
To remove a module, unlock it from the DIN rail by placing a screwdriver in the slot on the
rail clip and opening the rail clip to the unlocked position as shown in step 1 on page 10.
Then lift the device off of the rail.
43169
Rail Clip Unlocked
Position Device Along DIN Rail
DIN Rail
Rail Clip Locked
Advertising