Rockwell Automation 1738-IB16DM12 ArmorPoint 24V DC 16 Point Input and Output Modules - Manual (Page 8)

8 ArmorPoint 24V DC 16 Point Input and Output Modules, Series A
Publication 1738-IN023B-EN-E - February 2010
Remove the Module From the Mounting Base
To remove the module from the mounting base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch.
The module lifts up off the base.
3. Pull the module off of the base.
Wire the Modules
Following are wiring instructions for the modules.
1738-OB16E19M23
19
12 1
18
15
14 16
13 17
11
2 10
3 9
4 8
5 7
6
(view into connector)
Pin 1 - 24V DC output 0 Pin 11 - 24V DC output 9
Pin 2 - 24V DC output 1 Pin 12 - Not Used
Pin 3 - 24V DC output 2 Pin 13 - 24V DC output 10
Pin 4 - 24V DC output 3 Pin 14 - 24V DC output 11
Pin 5 -24V DC output 4 Pin 15 - 24V DC output 12
Pin 6 - Common Pin 16 - 24V DC output 13
Pin 7 -24V DC output 5 Pin 17 - 24V DC output 14
Pin 8 -24V DC output 6 Pin 18 - 24V DC output 15
Pin 9 -24V DC output 7 Pin 19 - Not used
Pin 10 - 24V DC output 8
44357