Rockwell Automation 1738-IJM23 ArmorPOINT I/O 5V DC Encoder/Counter Modules, Series A - Manual (Page 6)

Publication 1738-IN012B-EN-E - August 2013
6 ArmorPOINT I/O 5V DC Encoder/Counter Module, Series A
Install the ArmorPOINT
Encoder/Counter Module
To install the ArmorPOINT Encoder/Counter module, proceed as follows.
1. Using a bladed screwdriver, rotate the keyswitch on the mounting base
clockwise until the number 2 aligns with the notch in the base.
2. Position the module vertically above the mounting base. The module
will bridge two bases.
3. Push the module down until it engages the latching mechanism. You will
hear a clicking sound when the module is properly engaged.
The locking mechanism will lock the module to the base.
Remove the ArmorPOINT Encoder/Counter Module From the
Mounting Base
To remove the module from the mounting base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the latch.
The module will lift up off the base.
3. Pull the module off of the base.
MOD
NET
1738-IJM23/A
5V dc
Encoder/Counter
A
B
Z
Module will bridge two bases.
43809