Rockwell Automation 1747-ACNR15 ControlNet Adapter Module Installation Instructions - Manual (Page 12)

12 ControlNet Adapter Module
Publication 1747-IN017C-EN-P - May 2001
Connecting Programming Terminals to the Network via the NAP
You can connect programming terminals to the ControlNet network by connecting
to the network access port (NAP). Two methods are shown below.
ATTENTION
!
Use the 1786-CP cable when connecting a programming
terminal to the network through NAPs. Using a commercially
available RJ-style cable could result in possible network
failures.
Using 1784-KTC or -KTCx communication card
and NAP
Programming
Terminal
1784-KTC or
-KTCx
1786-CP 1
ControlNet
product
ControlNet network
Using 1770-KFC communication
interface and NAP
Programming
Terminal
Serial or Parallel
Connection
ControlNet Network
1. The 1786-CP cable can be plugged into any ControlNet product’s NAP to provide programming capability on the
ControlNet network. A programming terminal connected through this cable is counted as a node and must have a
unique address.
1786-CP 1
1770-KFC
ControlNet
product