Rockwell Automation 1771-OND INSTL.INSTR AC (24V) OUTPT.MOD - Manual (Page 4)

AC (24V) Output Module 4
Publication 1771Ć5.41 - May 1996
Installing the Output Module
To install the ac output module in your 1771 I/O chassis, follow the
steps listed below.
!
ATTENTION: Remove power from the 1771 I/O
chassis backplane and wiring arm before removing or
installing the module.
•
Failure to remove power from the backplane or field
wiring arm could cause module damage, degradation
of performance, or injury.
•
Failure to remove power from the backplane could
cause injury or equipment damage due to possible
unexpected operation.
1. Turn off power to the I/O chassis.
2. Place the module in the plastic tracks on the top and bottom of the
slot that guides the module into position.
3. Do not force the module into its backplane connector. Apply firm,
even pressure on the module to seat it properly.
4. Snap the chassis latch over the top of the module to secure its
position.
5. Connect the wiring arm to the module.
6. Make wiring connections to the field wiring arm as indicated in
Figure 2 .