Rockwell Automation 2707-MVH232_MVP232 MicroView Operator Interface Module - Manual (Page 48)

Publication 2707-UM005B-EN-P - July 2000
6-4 Installing the MicroView Operator Interface
4. Alternately tighten the mounting nuts until the terminal is held
firmly against the panel. Tighten mounting nuts to a torque of
10 inch-pounds. Do not over-tighten nuts.
3.888 in.
(98.8 mm)
3.490 in.
(88.6 mm)
0.199 in.
(5.05 mm)
0.760 in.
(19 mm)
3.660 in.
(93.0 mm)
5.180 in.
(131.0 mm)
Cutout Must
Not Exceed
Outside of line
0.172 in.
(4.37 mm)
TOP - FRONT
Make sure cutout is positioned with TOP - FRONT visible on the
front of the panel before marking.