Rockwell Automation MPL-xxxx Low Inertia Servo Motor 215 mm or Larger - Manual (Page 20)

20 MP-Series Low-inertia Servo Motor with 215 mm or Larger Frame Size
Rockwell Automation Publication MP-IN002D-EN-P - January
Motor Cables and Accessory Kits
This section describes accessories that are available for MP-Series low-inertia motors.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. They
provide the sealing needed to achieve environmental ratings and shield termination.
For a complete listing of available cables, contact your nearest Rockwell Automation sales office
or refer to the Kinetix Motion Accessories Specifications Technical Data, publication
GMC-TD004 .
Shaft Seal Kits
A shaft seal is a barrier that can prevent moisture and particles from entering the motor bearings.
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is
recommended every 3 months, not to exceed 12 months, depending on use.
Catalog numbers for the motors and corresponding replacement Nitrile shaft seal kits are listed
in the table.
For instructions on how to install a shaft seal, refer to the Shaft Seal Kit Installation Instructions,
publication
2090-IN012 .
IMPORTANT Shaft seals must be lubricated. Lubricant is supplied with the shaft seal kits.
Third-party shaft seals are not approved for use with these motors. The use of third-party shaft seals voids any
implied or expressed warranties.
Motor Cat. No. Shaft Seal Kit Cat. No.
MPL-B640, MPL-B660, MPL-B680 MPL-SST-A6B6
MPL-B860, MPL-B880 MPL-SST-A8B8
MPL-B960, MPL-B980 MPL-SST-A9B9