Autocue WINCUE - Manual (Page 80)

WINCUENEWS PROMPTER GUIDE APPENDIX B
80     AUTOCUE LTD. 2002
Appendix B The I.M.T. Card
In the following appendix we will look at the entire configuration options available for the I.M.T. board.
Contents
Card Layout B2
Termination - J6 B3
Power to Bus for SCSI Termination - J6 B3
SCSI ID – SW2 B4
SCSI/Parallel Select - SW2 B4
Video (PAL or NTSC) - J11 B5
SECAM B5
External Power Supply - J12 B6
Composite Video Features Connector - J10 B6
Other Jumpers B6
The I.M.T. card is configured at the factory to work in your country. It is unlikely that you will need to make
any changes to it. If you do, read the relevant section(s) carefully, or consult your supplier for further help
before changing the configuration of the board.
B2 Card Layout
The following section shows the 3 I.M.T. card layouts that have been produced over the years, most recent of which
being the Issue 3 I.M.T card. You will have been supplied with one of the 3 IMT cards, use the diagrams below to
help you locate all the connectors and jumpers on the card that you have been supplied with.