Autocue WINCUE User Manual
Page 86
WINCUE USER GUIDE
APPENDIX B
86
AUTOCUE LTD. 2002
SECAM
To configure the I.M.T. card for SECAM composite video output use the
same jumper setting as PAL on J11. In the WinCueNews software, from
the Prompt menu choose Configuration then Prompt Engine and ensure
that Colour Burst is disabled. These settings will generate a mono
composite output.
B6 Internal and External Power Supply - J12
If there is not an ISA slot available in your PC for the I.M.T card you will
have to use the J12 External Power Header (as shown in the diagram
below) to connect the IMT card to your PCs power supply. To do this firstly
check to see if you have a free power socket in your PC, then use the
supplied power adapter cable to connect the J12 External Power Header
to a free Power Header on your PCs power supply.
In systems where the I.M.T. card is not fitted inside the PC, it is powered by
an external power supply. This power supply is connected to J12. This
J12 External
Power Header
4 Way Power
Plug