Bang & Olufsen BeoVision MX_4002 - User Guide - Manual (Page 17)

17
Main room system and link room system
• To be able to start a DVD or CDV player
connected to your main video system, press
DVD on Beo4, then GO. Now operate your DVD
or CDV player as usual.
*Note: In order to display PHONO, A.TAPE2,
V.TAPE2
and AV on Beo4, you must add the
functions to the Beo4 list of functions, please
refer to Beo4’s own User’s guide and the chapter,
Customising your Beo4, for further information.
Link room system
Main room system
• If your main Bang & Olufsen system is in
standby when you switch it on via your TV, you
will only get sound and pictures on your TV –
neither the speakers, nor the TV screen in your
main system will be cut in.
• If you try to switch on a source in your main
Bang & Olufsen system, and you get the
pictures and/or the sound from a different
source on your TV, it may be because a
recording (audio or video) is progressing in your
main system.
• When you watch a video source from your main
system, for example a satellite programme, you
will get pictures and mono sound on your MX
4002 TV.
To obtain pictures and stereo sound (if any is
available), you must use the AV* LIST button:
press, for example, SAT, LIST until AV* appears,
then SAT. (To obtain the stereo sound alone,
just press LIST until AV* appears, then SAT, you
must do it from standby, though).
• To start playback on a Bang & Olufsen record
player in your main system, press LIST until
PHONO
* is displayed, then GO. Pressing ▲ or ▼
while you are listening to a record makes the
record player step through the music in 8 mm
steps.
• To start playback on a secondary Bang &
Olufsen audio- or video tape recorder in your
main system, press LIST until either A.TAPE2* or
V.TAPE2*
are displayed, then GO.