Bang & Olufsen BeoVision MX_4002 - User Guide - Manual (Page 28)

B E O V I S I O N M X 4 0 0 2 …
28
Sockets on the rear panel
Aerial
Connect the cable from your external aerial to the
aerial socket marked UHF & VHF on the rear panel
of the TV.
Note: The socket marked TRANSPOSER is for a
special transposer required for the French SECAM
L TV system.
Stand
The 4-pin DIN socket is for connection of a Bang &
Olufsen motorized stand or -base.
Active speakers
The 8-pin DIN sockets marked POWER LINK 1 and
POWER LINK 2 are for connection of active
speakers.
Note: See pages 30-31 for details of how to
program your speakers into the TV.
Passive speakers
You may connect external, passive speakers (8
ohm) to the speaker sockets marked R (right) and
L (left).
AV connection
The socket marked AV1 is for connection of
your primary video tape recorder, for example
the Bang & Olufsen BeoCord VX 7000 or V 8000
video tape recorder.
The socket marked AV2 is for connection of all
other AV equipment, for example a second
video tape recorder, a video camera, a DVD or
CDV player, a decoder or a socket expander.
Note: See pages 30-31 for details of how to
program your AV connections into the TV.
Super VHS connection
The S-VHS socket is for connection of a video
tape recorder or video camera using the S-VHS
format.
Note: Remember also to connect your S-VHS
connection to the AV1 or AV2 socket for
reproduction of sound.
Note: See pages 30-31 for details of how to
program your S-VHS connection into the TV.
Please note…
Any equipment you connect should be
registered in the TV Sockets menu in order for
you to operate them. Please refer to page 30-
31 for further information.
Mains
Plug the mains lead attached to the TV into the
mains socket.
Note: The attached mains lead and plug are
specially designed for this TV. If you change the
plug or in any way damage the mains lead, it
will affect the TV picture adversely.
Once the TV is connected to the mains, the
standby indicator on the front of the TV lights up
in red. The TV is now in standby mode, ready to
be operated with the Beo4 remote control.
Whenever the TV is switched on, the standby
light turns green.
BeoLink connection
For connection to your central system please refer
to the setting-up guide enclosed with your
BeoVision MX 4002.
POWER LINK 2 POWER LINK 1
B&O STAND
16V = / 300mA
R 8 OHM L
AV
2
AV
1
S-VHS
UHF & VHF
75 Ω