Baumfolder Flexifold: 1st Station (from 2005) - Manual (Page 23)

TP10494A PAGE 23
Figure 4.1-1
WARNING
Do not plug the power cord into an AC outlet until
the Flexifold Air Feed is fully assembled, adjusted and
ready to use. Unplug the Flexifold any time disassembly
is required.
4.0 ASSEMBLY
4.1 Main Unit
To assemble the Flexifold Air Feed unit, first remove
the four bolts holding it to the skid. Place the folder on the
stand (See Figure 4.1-1).
4.3 Pump Hose Connections
Two hoses come with your Flexifold Air
(See Figure 4.3-1)
Air
Vacuum
For
Pump
Hoses
Figure 4.3-1
4.2 Pump Electrical Connections
The pump has a plug/cord set attached. This plug fits
directly into the rear of the left-hand side cover. (See Figure
4.2-1)
Pump
Plug/Cord Set
Figure 4.2-1
4.4 Delivery Table
To install the delivery table, insert the delivery table
with the drive wheel toward the fold rolls. Slide the deliv-
ery table over both sets of locating pins.
The first notch in the front part of the delivery table
should rest on the pins. Then drop the rear notch down on
the rear dowel pins.
Rotate the handwheel to check that the gears are
properly meshed.
Plug the delivery table into the table receptacle on
the input/output Power assembly.( See Figure 4.2-1)
4.5 Feed Table Assembly Installation
Insert the feed table with the feed wheel toward the
fold rolls. Slide the paper feed table over both sets of
locating pins.
The first notch in the front part of the feed table
should rest on the pins. Then drop the rear notch down on
the upper dowel pins.
Rotate the handwheel to check that the gears are
properly meshed.
Connect the feed table hoses. Push the fittings into
the holes in the manifold block. (See Figure 4.5-1)
Delivery Table Receptacle
Be sure to route cables and hoses on floor in
a manner to prevent people from tripping over
them.
Do not operate machine without
delivery table in place!