Baumfolder Flexifold: 1st Station (from 2005) - Manual (Page 34)

PAGE 34 TP10494A
NOTE: If a button is not pressed within
2 minutes the machine will return
to the operating mode.
12.4 Speed
The speed of the machine can be changed by pressing
the “SPEED” button while the main drive motor is running
or stopped.
Using the “+” and “-” buttons, to adjust the speed.
The “+” button will increase the speed gradually, as
long as the button is depressed. Once the folder reaches
it’s maximum speed a message will be displayed until the
ENTER button is pressed.
The “-” button will decrease the speed gradually, as
long as the button is depressed.
Once the folder reaches it’s minimum speed a mes-
sage will be displayed until the “ENTER” button is pressed.
Full speed range travel of the motor takes 10 seconds.
Press the “ENTER” button to return to normal operation.
12.5 Fold Plates
The fold plate can be set at any time from the operat-
ing mode by pressing the “PLATE” button that corresponds
to the fold plate which needs to be adjusted.
For example if you need to make an adjustment to
the number 2 fold plate you would press the “PLATE 2”
button.
Next use the “+” and “-” buttons to move the stop
into position. Once either button is pressed the display will
change to display the actual location of the plate stop.
SPEED 60%
CHANGE WITH +/-
MAXIMUM SPEED
CHANGE WITH +/-
MINIMUM SPEED
CHANGE WITH +/-
TOTAL COUNT #######
BATCH ### #####
PAN 2 STOP 100.00mm
CHANGE WITH +/-