Bendix Commercial Vehicle Systems C-300N HYDRAULIC POWER STEERING1/99 - Manual (Page 17)

17
FIGURE 34 - VALVE NUT & VALVE BODY FIGURE 36 - SPINDLE ASSEMBLY BALL BEARING
FIGURE 33 - VALVE NUT TO VALVE BODY SAFETY POINT
FIGURE 32 - INPUT SHAFT DUST SEAL
FIGURE 35 - REMOVING/INSTALLING SPINDLE ASSEMBLY
externally without removal of the valve body (7) from the
housing (22). See the inset in figure 4 and 11.
Remove the steering limiting stem protective plug (21)
from the valve body (7) and using a screw driver, remove
the steering limiting stem (19) and O-ring (20) from the
valve body (7). Separate and discard the O-ring (20)
from the stem (19).
20. Remove the input shaft dust seal (4) from the valve nut
(1). Figure 32
21. With a drift punch, unblock the safety point between
the valve nut (1) and valve body (7). Using Spanner
wrench 106234 loosen and remove the valve nut (1) from
the valve body (7). Figures 33 & 34
22. Grasp the input shaft end of the spindle assembly(3)
and lift the spindle assembly (3), ball cage (6), 17 balls
(9) and one half of the outer race (8) out of the valve
body. Figure 35