Bendix Commercial Vehicle Systems C-300N HYDRAULIC POWER STEERING1/99 - Manual (Page 21)

21
FIGURE 44 - INSTALLING SPINDLE ASSEMBLY FIGURE 45 - INSTALLING PRESSURE SEAL IN VALVE NUT
torque the valve nut to between 221 and 257 pound feet.
Figure 34
Reset the safety point between the valve nut and valve
body using a drift punch or similarly appropriate tool.
Figure 33
11. If the steering gear was equipped with the steering
limiting feature follow the appropriate stem installation
procedure.
C-300N POWER STEERING GEAR
If it was necessary to remove the limiting stem from the
valve body, install the stem (13) now. Using the dimension
given in the vehicle manufacturer’s maintenance
manual, apply Loctite 222 or 262 to the threads and
screw the limiting stem (13) into the valve body (7) until
the correct stem height is obtained above the valve body
surface. IMPORTANT: Use care in applying the
Loctite compound to prevent this material from
coming in contact with other surfaces of the valve
body. Figure 4 & 11
C-500N POWER STEERING GEAR
Using lithium grease, lubricate and install the O-ring
(20) in the groove in the steering limiting stem (19).
Screw the assembled stem and O-ring into the valve
body (7) about 5 or 6 turns. Do not install the plug (21)
in the valve body at this time. Figure 4 & 11 inset
12. Install the dust seal (4) in the valve nut (1) taking care
not to damage the seal. Figure 32 The cavity between
the external dust seal (2), the dust seal(4) and fIuid seal