Export battery data – BLUESHAPE BSMon v3.0 User Manual
Page 14
is launched. The charts are available when at least 2 samples are read from
the battery. If not, this button is disabled (grayed).
If BSMon is reading data from the battery, the chart will show real time data.
If BSMon is not reading from the battery, the chart is available only if the previous read had collected enough data. In
this case the chart will show the last data logged from the battery.
This button will reset the battery.
By resetting the battery, the entire chipset will be forced to reload all the software and the programmed parameters.
This action is normally not necessary but could be helpful if a very critical condition occurs.
On resetting, the remaining capacity is zeroed (naturally, the battery will still hold its real capacity...), and
recalculated as soon as possible (normally within 1 minute) by a performance of an estimation based on the cell
stack voltage. The result of this self compensation is a Remaining State of Charge set either at 25%, 50% or 75%,
depending on voltage.
The misalignment between the real capacity and the estimated capacity calculated in this way will not pose a
problem since the battery will re-calibrate and re-align the remaining state of charge with the full state of charge each
time upon reaching full charge or full discharge.
This button allows the battery to send information to Blueshape® support team by email.
When clicked, the entire parameter table of the battery and additional real time data are downloaded from the battery
within a few seconds and the
is displayed for uploading battery data to our servers.
With this button it is possible to re-program the battery by uploading special settings.
When clicked, the
is displayed.
Export Battery data
Through this function it is possible to share battery data with Blueshape® customer support service.
Please note that to operate this, an internet connectivity is required .
Created with the Standard Edition of HelpNDoc: