Connection status – BLUESHAPE BSMon v3.0 User Manual
Page 18
by the user, when pressing the stop button in the control frame: the read session continues, but the load is cleared
by the user, when pressing the
to terminate the read session
by the system, when the minimum battery voltage is reached or when an automatic temperature, current or power
protection occur in the CBA unit
Connection status
The bottom border of the main form shows the actual connection status.
Left side: BSMon status
this section provides information about the status of the communication between PC and BSMon:
when the communication is active, a green mark will appear citing number 0 in square brackets
If the communication is not good, a red mark will notify it, and a related error message and number will explain the
reason.
The following are the most probable error conditions:
means that during start-up of BSMon, the USB device had not been detected by the PC
means that the PC could not detect the USB device (BSMon) properly
means that the USB device (BSMon) is no longer responding to the PC
means that the battery is not responding or not properly connected to the USB device (BSMon)
Right side: CBA status
a red mark means that the CBA Unit is disconnected and not communicating
a green mark means that CBA load is connected properly. In this case, additional status information are provided in
bracket:
0: the unit is idle
1: the load is working, a test is running
2: the test terminated naturally, the battery low voltage limit has been reached
3: the test halted because the CBA unit overheated
Created with the Standard Edition of HelpNDoc: